Used Phone Check
Test display, touch grid, multi-touch, stereo speakers, microphone, front/rear cameras, sensors, 120Hz refresh rate, and GSM locks directly in your mobile browser.
Display, Dead Pixels & OLED Burn-in
Set screen brightness to 80–100%, open fullscreen mode, and tap through each solid color and pattern to spot dead pixels, bright spots, color tint, or OLED burn-in.
Fullscreen Edge-to-Edge Touch Grid
Open the fullscreen touch grid and drag your finger across every cell—especially along the top notch, curved edges, and keyboard typing zone. Any cell that refuses to turn green indicates a dead touch strip.
Multi-touch & Ghost Touch Test
Place 3, 5, or up to 10 fingers simultaneously inside the dark test area below. Good screens track at least 5–10 points smoothly without jumping or ghost touches.
Stereo Speakers & Frequency Rattle Test
Turn your media volume up to 80–100%. Test the left channel (earpiece speaker), right channel (bottom speaker), stereo balance, and run the 120Hz–6kHz sweep to detect membrane rattle.
Microphone Recording & Live Waveform
Grant microphone permission, speak normally or tap gently near the bottom and top mics for up to 10 seconds, then play back the recording to check clarity and background hiss.
Front & Rear Camera + Sensor Dust Snapshot
Open the front and rear cameras, point at a bright white surface to inspect for purple/black sensor dust spots, verify autofocus, and take a test snapshot.
Vibration Motor, Motion Sensors & Display Refresh Rate (Hz)
Verify the Taptic/vibration motor, check real-time screen refresh rate (60Hz vs 120Hz ProMotion to spot cheap aftermarket screens), and tilt your phone to test the gyroscope/accelerometer.
Pre-Purchase Checklist & Hidden GSM Locks (iCloud / FRP / MDM / Knox)
Tick off the physical and security checks below that cannot be automated by a browser. Never hand over cash before performing a full Factory Reset to expose hidden iCloud, FRP, MDM, or Knox Guard locks.
- *#06# — Display IMEI1, IMEI2, EID & MEID instantly.
- Settings > General > About: Check Model Number (M = Retail new, N = Apple Replacement, F = Refurbished) and Parts & Service History.
- True Tone & Night Shift: Long-press the brightness slider in Control Center—if True Tone is missing, the screen was likely replaced without EEPROM transfer.
- Analytics Panic Full Check: Go to Settings > Privacy & Security > Analytics & Improvements > Analytics Data and scroll to letter P. Any "panic-full" or frequent "ResetCounter" log indicates a motherboard hardware fault!
- Samsung: Dial
*#0*#for hardware test menu,*#06#for IMEI/SN, and*#1234#for CSC/Firmware version. - Xiaomi / Redmi / POCO: Dial
*#*#6484#*#*or*#*#64663#*#*(CIT Hardware Test) and check Mi Unlock Status in Developer Options. - OPPO / Realme / OnePlus: Dial
*#899#for EngineerMode diagnostic menu. - Universal Android:
*#*#4636#*#*to inspect phone radio, LTE/5G signal strength, and usage statistics.
Use our instant 24/7 IMEI check service or rent UnlockTool, TSM Tool, Griffin-Unlocker, AMT, and HFZ iCloud Bypass automatically.
Used Phone Diagnostic Report — GSM24h.com
| # | Diagnostic Item | Result |
|---|